RunningStudies - Meg Wiki

Revision 68 as of 2015-03-12 09:21:38

Clear message
location: RunningStudies


Running MEG studies




Stimulus Presentation

Response Collection


Eye Tracking

Subject Preparation

Check Stimulus Before Testing

Acquisition Tips


Before you start your study

  • You have to become a "Qualitified MEG Researcher", as outlined in our Standard Operating Procedures (SOPs). This can take up to about 4 weeks. Contact to start the process.

  • You need IMC/IIG approval for your study.

  • You have to create an acquisition set-up for your study, e.g. specifying whether you will record EEG, EOG, ECG, low-pass filters etc. You should contact Olaf Hauk well in advance in order to arrange a meeting in the MEG lab.

  • Every MEG recording needs to be operated by a "Qualified MEG Operator" (see SOPs). If you want to operate recordings yourself (in company of another qualified researcher), you need to undergo additional training as specified in the SOPs. This training has to be arranged on an individual basis, and we currently cannot guarantee a specific time frame.

  • Pilot your study: 1) Test your stimulus presentation software on the "CBU mimic" PC in the computer users room. This PC has the same settings as the stimulus presentation PCs in the MRI and MEG labs. 2) Run an "emtpy room recording" in the MEG lab to make sure your stimulus presentation works in the MEG lab, and your recording settings are correct (e.g. MEG, EEG, EOG/ECG channels, triggers). Contact or Olaf Hauk to arrange this. 3) Run a proper pilot (ideally with a participant you know), and run some basic analyses to make sure the data are what you expected.

During Data Acquisition

While it is the responsibility of the qualified MEG operator to make sure the recording is running smoothly, the researcher should make sure all the settings for stimulus presentation and data acquisition are correct.

These are a few things to look out for at the beginning of each recording:

  • Check if stimulus presentation equipment and response collection work as desired (are stimuli audible, visible etc.?)
  • Has the correct preparation (incl. digitisation and subject ID) been loaded?
  • Have the correct project and acquisition settings been loaded?
  • Are triggers visible in STIM channel?
  • Does the EEG look ok? Note bad channels.
  • Are HEOG/VEOG/ECG in correct channels and look ok?


If you are using any non-standard equipment or make any changes in the settings (be they hardware or software), make sure to undo your changes in the end of your recording slot and leave the lab in the same state you found it before the recording.

For your general information, manuals for the data acquisition software are available to people with Cambridge approved logins at ElektaSoftwareManuals.